Lexus NX: Headlight Cleaner Actuator Cover
Components
COMPONENTS
ILLUSTRATION
| *1 | HEADLIGHT CLEANER WASHER NOZZLE COVER LH | *2 | HEADLIGHT CLEANER WASHER NOZZLE COVER RH |
| *3 | HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH | *4 | HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH |
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT BUMPER ASSEMBLY
(a) Remove the front bumper assembly.
(1) for Sport Package:
Click here .gif)
(2) except Sport Package:
Click here
2. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH
Click here
3. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH
HINT:
Use the same procedure described for the RH side.
4. REMOVE HEADLIGHT CLEANER WASHER NOZZLE COVER RH
| (a) Detach the 2 claws and remove the headlight cleaner washer nozzle cover RH. |
|
5. REMOVE HEADLIGHT CLEANER WASHER NOZZLE COVER LH
HINT:
Use the same procedure described for the RH side.
Installation
INSTALLATION
PROCEDURE
1. INSTALL HEADLIGHT CLEANER WASHER NOZZLE COVER RH
(a) Attach the 2 claws to install the headlight cleaner washer nozzle cover RH.
2. INSTALL HEADLIGHT CLEANER WASHER NOZZLE COVER LH
HINT:
Use the same procedure described for the RH side.
3. INSTALL HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH
Click here .gif)
4. INSTALL HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH
HINT:
Use the same procedure described for the RH side.
5. INSTALL FRONT BUMPER ASSEMBLY
(a) Install the front bumper assembly.
(1) for Sport Package:
Click here
(2) except Sport Package:
Click here
READ NEXT:
Headlight Cleaner Control Relay (for Single Beam Headlight)
ComponentsCOMPONENTS ILLUSTRATION *1 FRONT BUMPER COVER *2 HEADLIGHT CLEANER CONTROL RELAY On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HEADLIGHT CLEANER CONTROL RELA
Headlight Cleaner Control Relay(for Triple Beam Headlight)
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HEADLIGHT CLEANER CONTROL RELAY (a) Remove the headlight cleaner control relay. (b) Measure the resistance according to the value(s)
Headlight Cleaner Motor
ComponentsCOMPONENTS ILLUSTRATION *1 FRONT BUMPER ASSEMBLY *2 HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY RemovalREMOVAL PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY Click here 2. REMOVE
SEE MORE:
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL REAR BUMPER PAD HINT:
When installing the rear bumper pad, heat the rear bumper cover and rear bumper pad using a heat light.
Use the same procedure described for the other side.
Standard: Item Temperature Rear Bumper Cover 20 to 30°C (68 to 86°F
Internal Control Module Software Incompatibility Not Programmed (U030051)
DESCRIPTION If the forward recognition camera cannot verify the vehicle information sent from the hybrid vehicle control ECU, the forward recognition camera stores DTC U030051. DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from U030051 Internal Control Modul
