Lexus NX: Dtc Check / Clear

DTC CHECK / CLEAR

DTC CHECK USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes.

(e) Check for DTCs.

Click here

Body Electrical > Air Conditioner > Trouble Codes

DTC CLEAR USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes.

(e) Clear DTCs.

Click here

Body Electrical > Air Conditioner > Clear DTCs

READ NEXT:

 Terminals Of Ecu

TERMINALS OF ECU AIR CONDITIONING AMPLIFIER ASSEMBLY (a) Disconnect the I50 air conditioning amplifier assembly connector. (b) Measure the resistance and voltage according to the value(s) in the tabl

 Check Mode Procedure

CHECK MODE PROCEDURE REFRIGERANT GAS VOLUME CHECK IN NORMAL OPERATION (CHECK A/C SWITCH INDICATOR AND DTC) *a Example (a) Turn the power switch on (READY). (b) Check that A/C switch indicator

 Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non

SEE MORE:

 Front Passenger Side Seat Belt Warning Light Malfunction

DESCRIPTION When the power switch is turned on (IG), the occupant detection ECU sends a signal to the airbag ECU assembly to indicate the state of the front seat inner belt assembly RH and also whether the front passenger seat is occupied. The airbag ECU assembly sends those signals to the combinati

 Reassembly

REASSEMBLY PROCEDURE 1. INSTALL NO. 2 MOULDING TAPE HINT: When installing the No. 2 moulding tape, heat the front bumper cover and No. 2 moulding tape using a heat light. Use the same procedure described for the other side. Standard: Item Temperature Front Bumper Cover 20 to 30°

© 2016-2026 Copyright www.lexunx.com