Lexus NX: Heating / Air Conditioning
Lexus NX Service Manual / Vehicle Interior / Heating / Air Conditioning
- Air Conditioning Amplifier
- Air Conditioning Panel
- Air Conditioning Pressure Sensor
- Air Conditioning System
- Air Conditioning Unit
- Ambient Temperature Sensor
- Blower Unit
- Compressor
- Condenser
- Cooler Expansion Valve
- Front Blower Motor
- Front Evaporator Temperature Sensor
- Heater Water Pump
- Humidity Sensor
- Ptc Heater Assembly
- Refrigerant
- Refrigerant Line
- Relay
- Room Temperature Sensor
- Solar Sensor
READ NEXT:
Air Conditioning Amplifier
ComponentsCOMPONENTS ILLUSTRATION *1 AIR CONDITIONING AMPLIFIER ASSEMBLY *2 INNER NO. 1 INSTRUMENT PANEL BRACE COVER RH RemovalREMOVAL PROCEDURE 1. REMOVE INNER NO. 1 INSTRUMENT PANEL B
Components
COMPONENTS ILLUSTRATION *1 AIR CONDITIONING CONTROL ASSEMBLY *2 CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY *3 COWL SIDE TRIM BOARD LH *4 DOOR SCUFF PLATE ASSEMBLY LH *5
SEE MORE:
Inspection
INSPECTION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSPECT REAR NO. 1 SUSPENSION ARM ASSEMBLY LH (a) Inspect the turning torque of the ball joint. (1) Install the installation nut to the ball j
Check Bus 5 Line for Short to GND
DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 15 (CA5H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 16 (CA5L) of the central gateway ECU (network gateway ECU) and termin
© 2016-2026 Copyright www.lexunx.com
