Lexus NX: Dtc Check / Clear
Lexus NX Service Manual / Vehicle Interior / Meter / Gauge / Display / Headup Display System / Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Head Up Display / Trouble Codes.
(e) Check for DTCs.
Body Electrical > Head Up Display > Trouble CodesCLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Head Up Display / Clear DTCs.
(e) Clear the DTCs.
Body Electrical > Head Up Display > Clear DTCsREAD NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Headup Display System DTC No. Detection Item Memory Link U0100 Lost Communication with ECM / PCM "A" DTC stored U0142 Lost Communication With
Lost Communication with ECM / PCM "A" (U0100,U0142,U023A)
DESCRIPTION
U0100: The meter mirror sub-assembly receives signals from the ECM via CAN communication.
U0142: The meter mirror sub-assembly receives signals from the main body ECU (multiplex netwo
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE OUTER MIRROR LH (a) Push the upper part of the mirror surface and tilt it. (b) Apply protective tape to the areas shown in the illustrat
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT NOTICE:
When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
PROCEDURE 1. INSTALL POWER STEERING MOTOR ASSEMBLY NOTICE:
Do not drop the power steering ECU with motor assembly, strike it with tools
© 2016-2026 Copyright www.lexunx.com
