Lexus NX: Headup Display System
- Parts Location
- System Diagram
- System Description
- Customize Parameters
- How To Proceed With Troubleshooting
- Problem Symptoms Table
- Terminals Of Ecu
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Lost Communication with ECM / PCM "A" (U0100,U0142,U023A)
- Main Switch Circuit
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *1 HEADUP DISPLAY SWITCH ASSEMBLY *2 METER MIRROR SUB-ASSEMBLY *3 FORWARD RECOGNITION CAMERA *4 NO. 2 ENGINE ROOM RELAY BLOCK - ECU-B NO.1 FUSE *5
System Diagram
SYSTEM DIAGRAM
System Description
SYSTEM DESCRIPTION HEADUP DISPLAY SYSTEM DESCRIPTION HINT:
The meter mirror sub-assembly receives signals from the combination meter assembly via the CAN communication line. Information is displaye
SEE MORE:
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use the following procedures to troubleshoot the rear power seat control system. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT 2. CUSTOMER PROBLEM ANALYSIS HINT:
In troubleshooting, confirm that the problem symptoms have been accura
Installation
INSTALLATION PROCEDURE 1. INSTALL ACCELERATION SENSOR (a) for RH side: (1) Install the acceleration sensor with the 2 nuts. Torque: 8.5 N·m {87 kgf·cm, 75 in·lbf} NOTICE:
Avoid any impact to the acceleration sensor.
Do not drop the acceleration sensor. If it is dropped, replace it with a ne
© 2016-2025 Copyright www.lexunx.com
