Lexus NX: Dtc Check / Clear

DTC CHECK / CLEAR

CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Combination Meter / Trouble Codes.

(e) Check for DTCs.

Body Electrical > Combination Meter > Trouble Codes

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Combination Meter / Clear DTCs.

(e) Clear the DTCs.

Body Electrical > Combination Meter > Clear DTCs

READ NEXT:

 Freeze Frame Data

FREEZE FRAME DATA FREEZE FRAME DATA (a) Whenever a meter DTC is detected, the combination meter assembly stores the current vehicle state as freeze frame data. CHECK FREEZE FRAME DATA (a) Connect the

 Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa

 Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Meter / Gauge System DTC No. Detection Item Link B1321 Lost Communication with EMV B1326 Lost Communication with Clock Device (Local-CAN)

SEE MORE:

 Disc cannot be Inserted or is Ejected Right After Insertion

CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur: A communication malfunction DTC may be stored. The radio receiver assembly may not

 Removal

REMOVAL PROCEDURE 1. REMOVE CONSOLE BOX ASSEMBLY Click here 2. REMOVE DOOR SCUFF PLATE ASSEMBLY LH Click here 3. REMOVE COWL SIDE TRIM BOARD LH Click here 4. DISCONNECT FRONT FLOOR CARPET ASSEMBLY (a) Using a clip remover, remove the clip. *1 Hook *2 Fastener

© 2016-2026 Copyright www.lexunx.com