Lexus NX: Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the blind spot monitor main switch (combination switch assembly) on.
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Codes.
HINT:
The blind spot monitor sensor RH and the blind spot monitor sensor LH both output DTCs. Therefore, check both blind spot monitor sensors for DTCs.
(f) Check for DTCs.
Click here .gif)
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the blind spot monitor main switch (combination switch assembly) on.
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Codes.
(f) Clear the DTCs.
Body Electrical > Blind Spot Monitor Master > Clear DTCs Body Electrical > Blind Spot Monitor Slave > Clear DTCsREAD NEXT:
Freeze Frame Data
FREEZE FRAME DATA FREEZE FRAME DATA (a) Whenever a DTC is detected, the blind spot monitor sensor stores the current vehicle (sensor) state as Freeze Frame Data. CHECK FREEZE FRAME DATA (a) Connect th
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Blind Spot Monitor System DTC No. Detection Item Note Link C1A45 Vehicle Speed Sensor - C1A46 Yaw Rate Sensor - C1A47 Steering An
SEE MORE:
Components
COMPONENTS ILLUSTRATION *1 CRUISE CONTROL MAIN SWITCH *2 SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) *3 STEERING PAD SWITCH ASSEMBLY *4 STEERING WHEEL ASSEMBLY *5 STEERING WHEEL HEATER CONTROL ASSEMBLY *6 SWITCH NO. 1 WIRE N*m (kgf*cm, ft.*lbf): Spec
Exhaust Gas Recirculation Control Circuit (P0403)
DESCRIPTION Refer to DTC P0401. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory P0403 Exhaust Gas Recirculation Control Circuit Both of the following conditions are met: (1 trip detection logic)
(a) The engine is running.
(b) Any of the
