Lexus NX: ECU Malfunction (C1611)
DESCRIPTION
If the clearance warning ECU assembly detects an internal malfunction during self-diagnosis, DTC C1611 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1611 | ECU Malfunction |
| Clearance warning ECU assembly |
CAUTION / NOTICE / HINT
NOTICE:
-
After the power switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Click here
.gif)
-
When disconnecting and reconnecting the auxiliary battery
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
-
After replacing an ultrasonic sensor or the clearance warning ECU assembly, perform the necessary procedures (adjustment, calibration, initialization or registration).
Click here
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Using the Techstream, check for DTCs according to the prompts on the screen.
Click here
HINT:
After turning the power switch from off to on (IG), wait 3 seconds or more before checking for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes(b) Clear the DTCs according to the screen on the Techstream.
Click here
(c) Recheck for DTCs.
Click here
| Result | Proceed to |
|---|---|
| DTC C1611 is output | A |
| DTC C1611 is not output | B |
| A | .gif) | REPLACE CLEARANCE WARNING ECU ASSEMBLY |
| B | | USE SIMULATION METHOD TO CHECK |
READ NEXT:
Steering Angle Sensor Failure (C1626)
DESCRIPTION This DTC is stored if the clearance warning ECU assembly receives a signal via CAN communication from the steering sensor that indicates an internal malfunction. DTC No. Detection Ite
G Sensor Failure (C1647)
DESCRIPTION The clearance warning sonar ECU assembly communicates with the airbag ECU assembly (yaw rate and acceleration sensor) via CAN communication, and if it is determined that the airbag ECU ass
Communication Error From Clearance Sonar ECU to VSC (C164B)
DESCRIPTION The electronically controlled brake system receives intelligent clearance sonar system information from the clearance warning ECU assembly via CAN communication. When it is determined that
SEE MORE:
Kick Sensor Circuit (B2205)
DESCRIPTION B2205 is output when the multiplex network door ECU detects that the kick door control sensor is stuck on. DTC No. Detection Item DTC Detection Condition Trouble Area B2205 Kick Sensor Circuit One of the following conditions is met for approximately 60 seconds or more:
Asc Speaker
ComponentsCOMPONENTS ILLUSTRATION *1 NO. 1 SPEAKER ASSEMBLY WITH BOX - - RemovalREMOVAL PROCEDURE 1. REMOVE CONSOLE BOX ASSEMBLY Click here 2. REMOVE NO. 1 SPEAKER ASSEMBLY WITH BOX (a) Remove the 4 bolts and disconnect the connector. (b) Detach the 2 claws used to t
