Lexus NX: Electrical Key Oscillator (for Front Floor)

Lexus NX Service Manual / Vehicle Interior / Theft Deterrent / Keyless Entry / Electrical Key Oscillator (for Front Floor)

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified

 Removal

REMOVAL PROCEDURE 1. REMOVE DECK BOARD ASSEMBLY Click here 2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 3. REMOVE REAR DECK FLOOR BOX Click here 4. REMOVE DECK FLOOR BOX LH Click here 5.

 Installation

INSTALLATION PROCEDURE 1. INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY NOTICE: Do not reuse dropped or damaged parts. (a) Attach the clamp and install No. 1 indoor electrical key antenna assem

SEE MORE:

 Hybrid Battery System Discharge Time Too Long (P0C76-523)

DTC SUMMARY MALFUNCTION DESCRIPTION The hybrid vehicle control ECU detects that the electrical charge stored in the high-voltage condenser of the inverter with converter assembly cannot be discharged. The cause of this malfunction may be one of the following: Inside of inverter voltage sensor (VH)

 Low Output Signal of Rear Speed Sensor RH (C1273,C1274,C1466,C1467)

DESCRIPTION Each speed sensor detects the wheel speed and sends the signals to the skid control ECU (brake booster with master cylinder assembly). These signals are used for ABS control. DTCs C1273 and C1274 are cleared when the speed sensor sends a wheel speed signal or when Test Mode ends. DTCs C1

© 2016-2026 Copyright www.lexunx.com