Lexus NX: Theft Deterrent / Keyless Entry
Lexus NX Service Manual / Vehicle Interior / Theft Deterrent / Keyless Entry
- Certification Ecu
- Electrical Key Oscillator (for Front Floor)
- Electrical Key Oscillator (for Luggage Compartment)
- Electrical Key Oscillator (for Outside Luggage Compartment)
- Electrical Key Oscillator(for Rear Floor)
- Engine Hood Courtesy Switch
- Id Code Box
- Immobiliser System
- Intrusion Sensor
- Security Horn Assembly
- Security Horn Assembly (for Built-in Battery Type)
- Smart Access System With Push-button Start (for Entry Function)
- Smart Access System With Push-button Start (for Start Function)
- Theft Deterrent System
READ NEXT:
Certification Ecu
ComponentsCOMPONENTS ILLUSTRATION *1 CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) *2 ECU INTEGRATION BOX RH *3 GLOVE COMPARTMENT DOOR ASSEMBLY *4 NO. 2 INSTRUMENT PANEL UNDER COVER
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified
SEE MORE:
Short in Knee Airbag (D Side) Squib Circuit (B1860-B1863)
DESCRIPTION The driver side knee squib circuit consists of the airbag ECU assembly and lower No. 1 instrument panel airbag assembly. This circuit instructs the SRS to deploy when deployment conditions are met. These DTCs are stored when a malfunction is detected in the driver side knee squib circuit
Inspection
INSPECTION PROCEDURE 1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition 5 (S) - 1 (GND) EV mode switch pushed and held Below 10 Ω
© 2016-2026 Copyright www.lexunx.com
