Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY
NOTICE:
Do not reuse dropped or damaged parts.
(a) Attach the clamp and install No. 1 indoor electrical key antenna assembly.
(b) Connect each connector.
2. INSTALL SHIFT LEVER ASSEMBLY
Click here .gif)
3. INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY
Click here
4. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
Click here
5. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
Click here
6. INSTALL NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
7. INSTALL NO. 1 SWITCH HOLE BASE
Click here
8. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Click here
9. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
10. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
11. INSTALL INSTRUMENT SIDE PANEL LH
Click here
12. INSTALL INSTRUMENT SIDE PANEL RH
Click here
13. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH
Click here
14. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH
Click here
15. INSTALL UPPER REAR CONSOLE PANEL
Click here
16. INSTALL CONSOLE ARMREST ASSEMBLY
Click here
17. INSTALL MULTI-DISPLAY ASSEMBLY WITH BRACKET
Click here
18. INSTALL INSTRUMENT PANEL FINISH PLATE
Click here
19. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
20. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
21. CHECK SRS WARNING LIGHT
Click here
22. INSTALL DECK FLOOR BOX LH
Click here
23. INSTALL REAR DECK FLOOR BOX
Click here
24. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
25. INSTALL DECK BOARD ASSEMBLY
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 TONNEAU COVER ASSEMBLY - - ILLUSTRATION *1 DECK BOARD ASSEMBLY *2 DECK FLOOR BOX LH *3 DECK FLOOR BOX RH - - ILLUSTRATION *1 DECK F
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY NOTICE: Do not reuse dropped or damaged parts. (a) Connect the connector. (b) Attach the clamp to install the No. 3 indoo
SEE MORE:
Steering Angle Sensor Unusual Bank Angle Detected (C1440)
DESCRIPTION If the skid control ECU (brake booster with master cylinder assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (brake booster with master cylinder assembly) stores DTC C1440 while VSC operation is temporarily disabled. This is not a malfunct
Voice Recognition Microphone Disconnected (B1579)
DESCRIPTION The radio receiver assembly and telephone microphone assembly are connected to each other using the microphone connection detection signal lines. This DTC is stored when a microphone connection detection signal line is disconnected. DTC No. Detection Item DTC Detection Condition
