Lexus NX: Exhaust Manifold
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 INVERTER RESERVOIR ASSEMBLY *2 NO. 1 ENGINE COVER SUB-ASSEMBLY *3 WIRE HARNESS - - N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR (a) Install the No. 2 exhaust manifold heat insulator with the 2 bolts. Torque: 13.5 N·m {138 kgf·cm, 10 ft·lbf} 2. INSTALL
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY Click here 2. REMOVE FAN AND GENERATOR V BELT Click here 3. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH Click here 4. REMOVE CRANKSHAFT PULLEY ASSEMBLY Click here 5. REMOVE TIMING CHAIN COVER OIL SEAL (a) Using a screwdri
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side) Cl
© 2016-2026 Copyright www.lexunx.com
