Lexus NX: Fail-safe Chart

FAIL-SAFE CHART

FAIL-SAFE FUNCTION

(a) When a malfunction occurs in the road sign assist system, a message will be displayed on the multi-information display and the road sign assist system will be disabled, depending on the malfunction.

Warning Message

Malfunction Status

Fail-safe Operation

DTC/Vehicle Control History (RoB)

Fail-safe Mode Deactivation Condition

X: Control is suspended

"RSA Malfunction Visit Your Dealer" is displayed

Road sign assist system is malfunctioning

X

DTC or vehicle control history stored

After system returns to normal, power switch is turned off and then to on (IG)

READ NEXT:

 Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa

 Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Road Sign Assist System DTC No. Detection Item Link U012587 Lost Communication with Multi-axis Acceleration Sensor Module Missing Message U012987

 Vehicle Control History

VEHICLE CONTROL HISTORY NOTICE: Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again. CHECK VEHICLE CONTROL HISTORY (ROAD SI

SEE MORE:

 Switch Operation of Remote Touch not Accepted

CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur: A communication malfunction DTC may be stored. The radio receiver assembly may not

 Dtc Check / Clear

DTC CHECK / CLEAR CHECK DTC AND FREEZE FRAME DATA (a) Turn the power switch off. (b) Connect the Techstream to the DLC3. (c) Turn the power switch on (IG) and the Techstream on. (d) Enter the following menus: Chassis / Electric Parking Brake / Trouble Codes. (e) Check for DTC. Chassis > Electric

© 2016-2025 Copyright www.lexunx.com