Lexus NX: Fail-safe Chart
Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Lighting System (for Triple Beam Headlight) / Fail-safe Chart
FAIL-SAFE CHART
FAIL-SAFE FUNCTION
(a) Headlight ECU sub-assembly
(1) The headlight ECU sub-assembly stops light operation if the following malfunctions are detected.
| Malfunction | Multi-information Display Warning | DTC Output | ||
|---|---|---|---|---|
| Lighting on/off | LED light source malfunction | Low beam | Displayed | Output |
| High beam | Not Displayed | Output | ||
| Fan malfunction | Displayed | Output | ||
| Other than above (communication with main body ECU (multiplex network body ECU)) | Displayed | Output | ||
| Automatic headlight beam level control system | Displayed | Output | ||
| AFS (adaptive front-lighting system) | Displayed | Output | ||
| Power supply | IG voltage line malfunction | Displayed | Output | |
| Other than an IG voltage line malfunction | Not displayed | Not output | ||
READ NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faul
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Lighting System (for Triple Beam Headlight) DTC No. Detection Item Link B1244 Light Sensor Circuit Malfunction B2414 Steering Position Sensor Malf
Vehicle Control History
VEHICLE CONTROL HISTORY CHECK THE VEHICLE CONTROL HISTORY (LIGHTING SYSTEM) HINT:
The vehicle control history data (lighting system) stores the history of the reject function and system protection
SEE MORE:
Initialization
INITIALIZATION INITIALIZE SLIDING ROOF SYSTEM NOTICE:
When the roof glass is adjusted or removed/installed, or the sliding roof drive gear sub-assembly is replaced, the glass position cannot be determined and the sliding roof drive gear sub-assembly must be initialized (pulse sensor initial posit
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL NO. 5 MOULDING TAPE (a) Clean the No. 5 moulding tape installation surface with a non-residue solvent. (b) Apply primer to the No. 5 mo
© 2016-2026 Copyright www.lexunx.com
