Lexus NX: Fr Sensor Initialization Incomplete (C1AF3)
DESCRIPTION
When it is judged that the front sensors have not been initialized, the clearance warning ECU assembly stores DTC C1AF3.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AF3 | Fr Sensor Initialization Incomplete | Front sensor not initialized |
|
CAUTION / NOTICE / HINT
NOTICE:
-
If DTC C1AF3 is output after performing repairs, turn the power switch on (IG) and turn the intelligent clearance sonar system on to clear the DTC.
Click here
.gif)
-
After replacing an ultrasonic sensor or the clearance warning ECU assembly, perform the necessary procedures (adjustment, calibration, initialization or registration).
Click here
PROCEDURE
| 1. | INITIALIZE FRONT CENTER ULTRASONIC SENSOR AND FRONT CORNER ULTRASONIC SENSOR |
(a) Initialize the front center ultrasonic sensor and front corner ultrasonic sensor.
Click here
|
.gif)
| 2. | CHECK FOR DTC |
(a) Using the Techstream, check for DTCs according to the prompts on the screen.
HINT:
After turning the power switch from off to on (IG), wait 10 seconds or more before checking for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes| Result | Proceed to |
|---|---|
| DTC C1AF3 is output | A |
| DTC C1AF3 is not output | B |
HINT:
If DTC C1AF3 is still output after initializing the front center ultrasonic sensor and front corner ultrasonic sensor 3 times, replace the clearance warning ECU assembly.
| A | .gif) | REPLACE CLEARANCE WARNING ECU ASSEMBLY |
| B | | END (FRONT SENSORS WERE NOT INITIALIZED) |
READ NEXT:
Rr Sensor Initialization Incomplete (C1AF4)
DESCRIPTION When it is judged that the rear sensors have not been initialized, the clearance warning ECU assembly stores DTC C1AF4. DTC No. Detection Item DTC Detection Condition Trouble Area
Control Module Communication Bus "A" Off (U0073,U0100,U0124,U0126,U0129,U0140,U0155,U0164,U0293)
DESCRIPTION These DTCs are stored if there is a malfunction in the CAN communication system connected to the clearance warning ECU assembly. HINT: If CAN communication system DTCs are stored, they may
CAN Communication Failure (Message Registry) (U1000)
DESCRIPTION When the clearance warning ECU assembly determines that the CAN communication circuit is malfunctioning during self-diagnosis, DTC U1000 is stored. DTC No. Detection Item DTC Detect
SEE MORE:
Absorber Control Actuator (for Rear Side)
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT ABSORBER CONTROL ACTUATOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: for LH Side Tester Connection Condition Specified Condition 1 (+) - 3 (-) 15 to 25°C 2.8 to 4.4
Speed Signal Circuit
DESCRIPTION The combination meter assembly receives the vehicle speed signal from this circuit. The wheel speed sensors produce an output that varies according to the vehicle speed. The wheel speed sensor output is received by the brake booster with master cylinder assembly (skid control ECU) which
