Lexus NX: Front Left Sensor Malfunction (C1AE1)
DESCRIPTION
The front corner ultrasonic sensor (FL sensor) is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front corner ultrasonic sensor (FL sensor). If the front corner ultrasonic sensor (FL sensor) has an open circuit or other malfunction, it will not function normally.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE1 | Front Left Sensor Malfunction | A malfunction of the front corner ultrasonic sensor (FL sensor) |
|
CAUTION / NOTICE / HINT
NOTICE:
If DTCs are output after repairs, turn the power switch on (IG) and the intuitive parking assist system on. Then clear the DTCs.
Click here .gif)
PROCEDURE
| 1. | CHECK DTC OUTPUT |
(a) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| No DTCs are output | A |
| Only DTC C1AE1 is output | B |
| DTC C1AE1 and C1AEC are output | C |
| A | .gif) | USE SIMULATION METHOD TO CHECK |
| C | | GO TO DTC (C1AEC) |
|
.gif)
| 2. | REPLACE FRONT CORNER ULTRASONIC SENSOR (FL SENSOR) |
(a) Replace the front corner ultrasonic sensor (FL sensor) with a known good one.
Click here
HINT:
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
|
| 3. | CHECK DTC OUTPUT |
(a) Clear the DTCs.
Click here
(b) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| No DTCs are output | A |
| DTC C1AE1 is output | B |
| A | | END (FRONT CORNER ULTRASONIC SENSOR [FL SENSOR] WAS DEFECTIVE) |
| B | | REPLACE CLEARANCE WARNING ECU ASSEMBLY |
READ NEXT:
Front Left Center Sensor (C1AE2)
DESCRIPTION The front center ultrasonic sensor (FLC sensor) is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front center ultra
Front Right Center Sensor (C1AE3)
DESCRIPTION The front center ultrasonic sensor (FRC sensor) is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front center ultra
Front Right Sensor Malfunction (C1AE4)
DESCRIPTION The front corner ultrasonic sensor (FR sensor) is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front corner ultras
SEE MORE:
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE AIR CONDITIONING RADIATOR ASSEMBLY (a) Disconnect the No. 1 blower damper servo sub-assembly connector. (b) Detach the 3 clamps and remove the air conditioning harness assembly. (c) Remove the 2 screws. (d) Detach the 2 claws and remove t
Power Source Mode does not Change to ON (READY)
DESCRIPTION When the electrical key transmitter sub-assembly is in the cabin and the power switch is pressed, the certification ECU (smart key ECU assembly) receives a signal and changes the power source mode. In addition, when the power switch is pressed with the shift lever in P and the brake peda
