Lexus NX: Lost Communication with Cruise Control Front Distance Range Sensor Single Sensor or Center Missing Message (U023587)
DESCRIPTION
The forward recognition camera communicates with the millimeter wave radar sensor assembly via CAN communication. If a communication malfunction between the forward recognition camera and millimeter wave radar sensor assembly is detected, DTC U023587 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| U023587 | Lost Communication with Cruise Control Front Distance Range Sensor Single Sensor or Center Missing Message | When the power switch is on (IG) for 3 seconds or more and the dynamic radar cruise control system is operating, a communication malfunction between the millimeter wave radar sensor assembly and forward recognition camera is detected for approximately 2 seconds or more. | Pre-collision system | Forward recognition camera |
PROCEDURE
| 1. | GO TO PRE-COLLISION SYSTEM |
HINT:
If DTC U023587 is output by the dynamic radar cruise control system, perform troubleshooting for the pre-collision system.
Click here .gif)
| NEXT | .gif) | END |
READ NEXT:
Internal Control Module Software Incompatibility Not Programmed (U030051)
DESCRIPTION If the forward recognition camera cannot verify the vehicle information sent from the hybrid vehicle control ECU, the forward recognition camera stores DTC U030051. DTC No. Detection
Internal Control Module Software Incompatibility Invalid/Incompatible Software Component (U030057)
DESCRIPTION If the vehicle information stored in the forward recognition camera does not match the vehicle information sent from the hybrid vehicle control ECU, the forward recognition camera stores D
Software Incompatibility with Brake System Control Module Not Programmed (U031851)
DESCRIPTION If the forward recognition camera cannot verify the vehicle information sent from the skid control ECU (brake booster with master cylinder assembly), the forward recognition camera stores
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY Click here 2. INSPECT HYBRID TRANSAXLE FLUID (a) Using a 10 mm hexagon socket wrench, remove the filler plug and gasket from the hybrid vehicle transaxle assembly. *1 Filler Plug *a 0 to 5 mm (0 t
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR DOOR LOCK ASSEMBLY LH (a) Check the door lock motor operation. (1) Apply auxiliary battery voltage to the motor connector and check the operation of the door lock motor. OK: Measurement Condition Specified Condition Auxiliary battery positive (+) →
