Lexus NX: Hv Battery
READ NEXT:
Charging
CHARGING PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing. Click here 2. INSPECT AUXILIARY BATTERY VOLTAGE Click here 3. PREPARATION FOR HV BATTERY CHARGING
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified
SEE MORE:
Check Bus 2 Line for Short to +B
DESCRIPTION There may be a short circuit between one of the CAN bus wire and +B when there is no resistance between terminal 18 (CA4H) of the central gateway ECU (network gateway ECU) and terminal 16 (BAT) of the DLC3, or terminal 17 (CA4L) of the central gateway ECU (network gateway ECU) and termin
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL STIFFENING CRANKCASE RING PIN NOTICE: It is not necessary to remove the ring pin unless it is being replaced. *a Protrusion Height (a) Using a plastic-faced hammer, tap in 2 new ring pins until they stop. Standard protrusion height: 4.3 to 5.3 mm (0.169 to 0
© 2016-2026 Copyright www.lexunx.com
