Lexus NX: 2ar-fxe (hybrid / Battery Control)
Lexus NX Service Manual / Engine & Hybrid System / 2ar-fxe (hybrid / Battery Control)
- Accelerator Pedal Sensor
- Battery Blower
- Battery Cooling Filter
- Battery Voltage Sensor
- Coolant (for Inverter)
- Frame Wire
- Hv Battery
- Hv Relay Assembly
- Hybrid Control System
- Hybrid Vehicle Control Ecu
- Inverter With Converter
- Relay
- Service Plug Grip
- Sub Radiator
- Water Pump With Motor
READ NEXT:
Accelerator Pedal Sensor
ComponentsCOMPONENTS ILLUSTRATION *1 ACCELERATOR PEDAL SENSOR ASSEMBLY *2 ACCELERATOR PEDAL SENSOR CONNECTOR N*m (kgf*cm, ft.*lbf): Specified torque - - On-vehicle Inspection
Components
COMPONENTS ILLUSTRATION *1 TONNEAU COVER ASSEMBLY - - ILLUSTRATION *1 DECK BOARD ASSEMBLY *2 DECK FLOOR BOX LH *3 NO. 3 DECK BOARD SUB-ASSEMBLY - - ILLUSTRATION
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart.
Click here PROCEDURE 1. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH
Blind Spot Monitor Slave Module (C1AB7)
DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects an internal malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area Note C1AB7 Blind Spot Monitor Slave Module The blind spot monitor sensor RH (slave) detects an internal malfunction B
© 2016-2026 Copyright www.lexunx.com
