Lexus NX: Hybrid Vehicle Transaxle

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 SERVICE PLUG GRIP *2 BATTERY SERVICE HOLE COVER *3 HYBRID BATTERY SERVICE PLUG COVER - - N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUST

 Removal

REMOVAL CAUTION / NOTICE / HINT CAUTION: The engine assembly with hybrid vehicle transaxle assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the engine lifter

 Installation

INSTALLATION PROCEDURE 1. INSTALL NO. 3 MOTOR WATER JACKET COVER ASSEMBLY Click here 2. INSTALL NO. 1 MOTOR WATER JACKET COVER ASSEMBLY Click here 3. INSTALL NO. 2 MOTOR WATER JACKET COVER ASSEMBL

SEE MORE:

 Installation

INSTALLATION PROCEDURE 1. INSTALL FUEL PUMP CONTROL ECU ASSEMBLY Click here 2. INSTALL PARKING BRAKE ECU ASSEMBLY (a) Install the parking brake ECU assembly with the 2 bolts. Torque: 8.0 N·m {82 kgf·cm, 71 in·lbf} (b) Connect the 3 connectors. 3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH Click

 Fail-safe Chart

FAIL-SAFE CHART If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily or stops fuel injection. DTC Code Component Fail-Safe Operation Fail-Safe Deactivation Condition P0031 P0032 P101D Air fuel ratio sensor heater The EC

© 2016-2026 Copyright www.lexunx.com