Lexus NX: Initialization
Lexus NX Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Parking Assist Monitor System / Initialization
INITIALIZATION
INITIALIZE PARKING ASSIST MONITOR SYSTEM
(a) When the "!" mark is displayed on the multi-display assembly, correct the steering angle neutral point using the following method.
(1) Fully turn the steering wheel to the right and left on flat ground.
NOTICE:
Memorizing the steering angle neutral point must be carried out with the power switch on (READY). Apply the parking brake, depress the brake pedal, check that the shift lever is in P, and ensure that the vehicle is not moving.
HINT:
If estimated course lines are not displayed on the image of the area behind the vehicle with the steering wheel fully turned to the right or left, perform "Steering Angle Setting in Calibration".
Click here .gif)
READ NEXT:
Calibration
CALIBRATION ADJUST PARKING ASSIST MONITOR SYSTEM (a) This parking assist monitor system can be adjusted using the diagnostic screen of the display. (b) If the following operations are performed, it is
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE:
The following inspection procedures for the parking assist monitor system are based on the assumption that the navigation system is normal. If the navigation system h
Terminals Of Ecu
TERMINALS OF ECU REAR TELEVISION CAMERA ASSEMBLY (a) Disconnect the Y25 rear television camera assembly connector. (b) Measure the voltage on the wire harness side connector according to the value(s)
SEE MORE:
Customize Parameters
CUSTOMIZE PARAMETERS CUSTOMIZE HEADUP DISPLAY SYSTEM (a) Customizing with the Techstream (1) Connect the Techstream to the DLC3. (2) Turn the power switch on (IG). (3) Turn the Techstream on. (4) Enter the following menus: Customize Setting / Display. (5) Select the setting by referring to the table
Inspection
INSPECTION PROCEDURE 1. CHECK BRAKE CYLINDER AND PISTON (a) Check the cylinder bore and piston for rust or scoring. If necessary, replace the brake cylinder and piston. 2. CHECK PAD LINING THICKNESS (a) Using a ruler, measure the pad lining thickness. Standard thickness: 12.0 mm (0.472 in.) Minimum
© 2016-2026 Copyright www.lexunx.com
