Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *A | w/ Steering Heater | - | - |
| *1 | CRUISE CONTROL MAIN SWITCH | *2 | SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) |
| *3 | STEERING PAD SWITCH ASSEMBLY | *4 | STEERING SHAKE DAMPER |
| *5 | STEERING WHEEL ASSEMBLY | *6 | STEERING WHEEL HEATER CONTROL ASSEMBLY |
| *7 | SWITCH NO. 1 WIRE | - | - |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| ★ | Precoated part | - | - |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE:
Do not replace the spiral with sensor cable sub-assembly with the battery connected and the power switch on (IG).
Do not rotate the spiral with sensor cabl
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE:
Do not replace the spiral with sensor cable sub-assembly with the battery connected and the power switch on (IG).
Do not rotate the spiral with sensor
SEE MORE:
Torque Sensor1 (C1511-C1514)
DESCRIPTION The torque sensor converts the steering wheel rotation torque into electric signals and sends them to the power steering ECU assembly. DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition C1511 Torque Sensor1 Torque
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL NO. 2 ROOF CARRIER PROTECTOR (a) Clean the roof rack surface. (1) Remove the double-sided tape from the roof rack. (2) Wipe off any tap
© 2016-2026 Copyright www.lexunx.com
