Lexus NX manuals

Lexus NX: Inspection

Lexus NX Service Manual / Steering / Steering Column / Tilt And Telescopic Manual Switch / Inspection

INSPECTION

PROCEDURE

1. INSPECT TILT AND TELESCOPIC SWITCH

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

1 (VC) - 3 (MSW)

Tilt up

342 to 378 Ω

Tilt down

1890.5 to 2089.5 Ω

Telescopic contract

750.5 to 829.5 Ω

Telescopic extend

152 to 168 Ω

If the result is not as specified, replace the tilt and telescopic manual switch.

*a

Component without harness connected

(Tilt and Telescopic Manual Switch)

READ NEXT:

 Installation

INSTALLATION PROCEDURE 1. INSTALL TILT AND TELESCOPIC SWITCH (a) Attach the claw to install the tilt and telescopic switch. (b) Connect the connector. 2. INSTALL LOWER STEERING COLUMN COVER (a) Attach

 Steering Gear / Linkage

 Steering Gear

SEE MORE:

 Lost Communication with Cruise Control Front Distance Range Sensor Single Sensor or Center Missing Message (U023587)

DESCRIPTION The forward recognition camera is connected to the millimeter wave radar sensor assembly via the CAN communication line. When the signal from the millimeter wave radar sensor assembly is interrupted, the forward recognition camera outputs U023587. DTC No. Detection Item DTC Detect

 Terminals Of Ecu

TERMINALS OF ECU TERMINALS OF ECU *a Component without harness connected (Skid Control ECU (Brake Booster with Master Cylinder Assembly)) - - Terminal No. (Symbol) Terminal Description 1 (MRI1) Motor power supply input 1 2 (MRI2) Motor power supply input 2 3 (STPO)

© 2016-2026 Copyright www.lexunx.com