Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL TILT AND TELESCOPIC SWITCH
(a) Attach the claw to install the tilt and telescopic switch.
(b) Connect the connector.
2. INSTALL LOWER STEERING COLUMN COVER
(a) Attach the 2 claws to install the lower steering column cover.
NOTICE:
Do not damage the tilt and telescopic switch.
(b) Install the 3 screws.
3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
4. INITIALIZATION AFTER RECONECTING AUXILIARY BATTERY TERMINAL
Click here .gif)
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
5. INSTALL DECK FLOOR BOX LH
Click here
6. INSTALL REAR DECK FLOOR BOX
Click here
7. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
8. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
(a) Reset the auto tilt away function setting to the previous condition by changing the customize parameter.
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FRONT FLOOR COVER CENTER LH *2 NO. 1 ENGINE UNDER COVER *3 REAR ENGINE UNDER COVER LH *4 REAR ENGINE UNDER COVER RH ILLUSTRATION *1 FRONT STABIL
SEE MORE:
Power Supply Drive Circuit (C1257)
DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) detects a drop in accumulator pressure according to the signals from the accumulator pressure sensor, then operates and stops the motor relay as well as the pump motor. The skid control ECU (brake booster with master cyli
Cooler Expansion Valve
ComponentsCOMPONENTS ILLUSTRATION *1 AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY *2 COOLER EXPANSION VALVE *3 O-RING - - N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part Compressor oil ND-OIL 11 or equivalent - - RemovalREMOVAL PROCEDURE 1.
