Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 1 AMPLIFIER ANTENNA ASSEMBLY
(a) Attach the guide and install the No. 1 amplifier antenna assembly with the bolt.
Torque:
8.3 N·m {85 kgf·cm, 73 in·lbf}
(b) Connect the 2 connectors.
2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY
Click here .gif)
3. INSTALL BACK DOOR LOCK COVER (w/o Power Back Door)
Click here
4. INSTALL BACK DOOR LOCK COVER (w/ Power Back Door)
Click here
5. INSTALL BACK DOOR FINISH COVER RH (w/o Power Back Door)
Click here
6. INSTALL BACK DOOR FINISH COVER LH (w/o Power Back Door)
Click here
7. INSTALL BACK DOOR TRIM BASE (w/ Power Back Door)
Click here
8. INSTALL PULL HANDLE (w/ Power Back Door)
Click here
9. INSTALL BACK DOOR SIDE GARNISH RH
Click here
10. INSTALL BACK DOOR SIDE GARNISH LH
Click here
11. INSTALL BACK DOOR CENTER GARNISH
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified
Removal
REMOVAL PROCEDURE 1. REMOVE DECK BOARD ASSEMBLY Click here 2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 3. REMOVE REAR DECK FLOOR BOX Click here 4. REMOVE DECK FLOOR BOX LH Click here 5.
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to follow the correct removal and installation procedures of the front seat cushion airbag assembly RH. HINT:
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
PROCEDURE 1. INSPECT F
Components
COMPONENTS ILLUSTRATION *1 CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY *2 INSTRUMENT SIDE PANEL LH *3 INSTRUMENT SIDE PANEL RH *4 LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL *5 NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY *6 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-AS
