Lexus NX: Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.
PROCEDURE
1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
(a) Attach the guide to install the millimeter wave radar sensor assembly.
.png) | Bolt |
.png) | Screw |
(b) Install the screw and 2 bolts.
HINT:
Tighten the bolts and screws in the order shown in the illustration.
Torque:
Bolt :
2.5 N·m {25 kgf·cm, 22 in·lbf}
2. INSTALL FRONT BUMPER ASSEMBLY
(a) for Sport Package:
Click here .gif)
(b) except Sport Package:
Click here
3. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY
(a) If the millimeter wave radar sensor has been replaced, the front of the vehicle has been repaired or modified, or the position of the beam axis change mechanism has been changed, perform adjustment.
Click here
READ NEXT:
Precaution
PRECAUTION HANDLING PRECAUTION FOR ROAD SIGN ASSIST SYSTEM (a) The system may not detect traffic signs under the following conditions:
The forward recognition camera is misaligned.
Dirt, snow, ic
Parts Location
PARTS LOCATION ILLUSTRATION *1 FORWARD RECOGNITION CAMERA *2 BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY - SKID CONTROL ECU *3 MILLIMETER WAVE RADAR SENSOR ASSEMBLY - - ILLUSTRA
SEE MORE:
Drive Motor "B" Position Sensor Circuit (P0A45-669-P0A47-670)
DTC SUMMARY MALFUNCTION DESCRIPTION These DTCs indicate the resolver output signal is abnormal. The cause of this malfunction may be one of the following: Area Main Malfunction Description Step Inverter low-voltage circuit The connectors are not connected properly 2 Rear motor res
Installation
INSTALLATION PROCEDURE 1. INSTALL STOP LIGHT SWITCH ASSEMBLY (a) Turn the stop light switch assembly in the clockwise direction until it reaches the standard shaft protrusion amount and temporarily install it. Standard: 0.5 to 1.7 mm (0.0197 to 0.0669 in.) NOTICE: Do not depress the brake pedal.
