Lexus NX: Installation

INSTALLATION

PROCEDURE

1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU

(a) Attach the claw and install the multiplex tilt and telescopic ECU to the bracket.

(b) Install the bolt and multiplex tilt and telescopic ECU to the electric power steering column sub-assembly.

(c) Connect the connector and harness clamp.

2. INSTALL LOWER STEERING COLUMN COVER

Click here

3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

4. INITIALIZATION AFTER RECONECTING AUXILIARY BATTERY TERMINAL

Click here

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click here

5. INSTALL DECK FLOOR BOX LH

Click here

6. INSTALL REAR DECK FLOOR BOX

Click here

7. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY

Click here

8. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

(a) Reset the auto tilt away function setting to the previous condition by changing the customize parameter.

Click here

READ NEXT:

 Removal

REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the power switch is turned off, there may be a waiting time before disconnecting the auxiliary negative (-) battery terminal. Click here 2. CUST

 Power Tilt And Power Telescopic Steering Column System

 Precaution

PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE: After turning the power switch off, waiting time may be required before disconnecting the cable from t

SEE MORE:

 Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be dis

 Removal

REMOVAL PROCEDURE 1. DISCONNECT WIRE HARNESS Click here 2. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR Click here 3. DISCONNECT INVERTER RESERVE TANK ASSEMBLY Click here 4. REMOVE AIR FUEL RATIO SENSOR (a) Remove the radiator hose clamp as shown in the illustration. Push (b) Disco

© 2016-2024 Copyright www.lexunx.com