Lexus NX: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
-
A bolt without a torque specification is shown in the standard bolt chart.
Click here
.gif)
PROCEDURE
1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
(a) Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH with the 3 "TORX" screws.
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
HINT:
A new power window regulator motor assembly LH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
Click here
3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
Click here
4. INSTALL REAR DOOR REAR GUIDE SEAL LH
Click here
5. INSTALL REAR LOWER REAR DOOR WINDOW FRAME SUB-ASSEMBLY LH
Click here
6. INSTALL REAR DOOR GLASS RUN LH
Click here
7. INSTALL REAR DOOR SERVICE HOLE COVER LH
Click here
8. INSTALL REAR DOOR ARMREST SET BRACKET LH
Click here
9. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
Click here
10. INSTALL REAR DOOR TRIM COVER LH
Click here
11. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH
Click here
12. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
Click here
13. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
14. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
15. INSTALL DECK FLOOR BOX LH
Click here
16. INSTALL REAR DECK FLOOR BOX
Click here
17. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
18. INITIALIZE POWER WINDOW CONTROL SYSTEM
Click here
19. CHECK POWER WINDOW
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK BOARD ASSEMBLY *2 NO. 2 DECK BOARD SUB-ASSEMBLY *3 NO. 3 DECK BOARD SUB-ASSEMBLY *4 TONNEAU COVER ASSEMBLY ILLUSTRATION *1 DECK FLOOR BOX L
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE TONNEAU COVER ASSEMBLY Click here
SEE MORE:
Customize Parameters
CUSTOMIZE PARAMETERS 1. CUSTOMIZE AIR CONDITIONING SYSTEM (a) Customizing with the Techstream HINT: The following items can be customized. NOTICE:
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settin
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable
