Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL WINDSHIELD WIPER RELAY ASSEMBLY
(a) Attach the 2 claws to install the windshield wiper relay assembly.
2. INSTALL ECU INTEGRATION BOX RH
Click here .gif)
3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
Click here
5. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Click here
6. INITIALIZATION AFTER RECONECTING AUXILIARY BATTERY TERMINAL
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
7. INSTALL DECK FLOOR BOX LH
Click here
8. INSTALL REAR DECK FLOOR BOX
Click here
9. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (a) w/o Auto Wiper System: Check the front wiper intermittent operation. (1) Connect a voltmeter positive (+) lead to ter
SEE MORE:
Switch Lights of Remote Touch Always Illuminate or cannot be Controlled Using Rheostat
DESCRIPTION Power is supplied to the remote touch illumination when the light control switch is in the tail or head position. HINT:
When the remote touch is in self check mode, the switch illumination on the remote touch may remain on.
If any illumination controlled by the rheostat switch has a
Power Back Door Control Switch
ComponentsCOMPONENTS ILLUSTRATION *1 BACK DOOR CONTROL SWITCH *2 PULL HANDLE RemovalREMOVAL PROCEDURE 1. REMOVE PULL HANDLE Click here 2. REMOVE BACK DOOR CONTROL SWITCH (a) Detach the 2 claws and remove the back door control switch. InspectionINSPECTION PROCEDURE 1.
