Lexus NX: Wiper / Washer

READ NEXT:

 Front Wiper Motor

 Components

COMPONENTS ILLUSTRATION *1 COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY *2 FRONT WIPER ARM HEAD CAP *3 WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH *4 WINDSHIELD WIPER ARM AND BLADE ASSEM

 On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (a) for LH Side: (1) Check the stop (park) position. *1 Ceramic Dot *2 Louver Lip Edge *a 34 mm

SEE MORE:

 Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH HINT: When installing the front fender moulding sub-assembly LH, heat the vehicle body and fron

 Dtc Check / Clear

DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Head Up Display / Trouble Codes. (e) Check for DTCs. Body Electrical > Head Up Display > Trouble Codes CLEAR DTC (

© 2016-2025 Copyright www.lexunx.com