Lexus NX: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL FRONT NO. 3 SPEAKER ASSEMBLY
NOTICE:
Do not touch the cone part of the speaker.
(a) Connect the connector and insert the 2 protrusions of the speaker bracket into the instrument panel cutouts.
(b) Install the front No. 3 speaker assembly with the 2 screws.
2. INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY
Click here .gif)
3. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY
NOTICE:
Do not touch the cone part of the speaker.
(a) Connect the connector and insert the 2 protrusions of the speaker bracket into the instrument panel cutouts.
(b) Install the front No. 2 speaker assembly with the 2 screws.
4. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
Click here
5. INSTALL FRONT PILLAR GARNISH ASSEMBLY LH
Click here
6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Click here
READ NEXT:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT RADIO SETTING CONDENSER (a) With the radio setting condenser installed, check that there is no looseness or other abnormalities. (b) Measure the resistanc
Removal
REMOVAL PROCEDURE 1. REMOVE REAR SEAT ASSEMBLY (for Manual Seat) Click here 2. REMOVE REAR SEAT ASSEMBLY (for Power Seat) Click here 3. REMOVE TONNEAU COVER ASSEMBLY Click here 4. REMOVE DE
SEE MORE:
Pcv Valve
ComponentsCOMPONENTS ILLUSTRATION *1 PCV VALVE SUB-ASSEMBLY *2 NO. 2 PCV HOSE N*m (kgf*cm, ft.*lbf): Specified torque Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent ★ Precoated part - - RemovalREMOVAL PROCEDURE 1. REMOVE INTAKE MANIFOLD Click here
Drive Motor "A" Position Sensor Circuit (P0A3F-243,P0A40-500,P0A41-245)
DTC SUMMARY MALFUNCTION DESCRIPTION These DTCs indicate the resolver output signal is abnormal. The cause of this malfunction may be one of the following: Area Main Malfunction Description Step Inverter low-voltage circuit The connectors are not connected properly 2 Resolver
