Lexus NX: Internal Control Module Software Incompatibility Invalid/Incompatible Software Component (U030057)
Lexus NX Service Manual / Engine & Hybrid System / Cruise Control / Dynamic Radar Cruise Control System / Internal Control Module Software Incompatibility Invalid/Incompatible Software Component (U030057)
DESCRIPTION
If the vehicle information stored in the forward recognition camera does not match the vehicle information sent from the hybrid vehicle control ECU, the forward recognition camera stores DTC U030057.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| U030057 | Internal Control Module Software Incompatibility Invalid/Incompatible Software Component | The vehicle information sent from the hybrid vehicle control ECU does not match that stored in the forward recognition camera. | Pre-collision system | Forward recognition camera |
PROCEDURE
| 1. | GO TO PRE-COLLISION SYSTEM |
HINT:
If DTC U030057 is output by the dynamic radar cruise control system, perform troubleshooting for the pre-collision system.
Click here .gif)
| NEXT | .gif) | END |
READ NEXT:
Software Incompatibility with Brake System Control Module Not Programmed (U031851)
DESCRIPTION If the forward recognition camera cannot verify the vehicle information sent from the skid control ECU (brake booster with master cylinder assembly), the forward recognition camera stores
Software Incompatibility with Brake System Control Module Invalid/Incompatible Software Component (U031857)
DESCRIPTION If the vehicle information stored in the forward recognition camera does not match the vehicle information sent from the skid control ECU (brake booster with master cylinder assembly), the
Software Incompatibility with Body Control Module Not Programmed (U032251)
DESCRIPTION If the forward recognition camera cannot verify the vehicle information sent from the main body ECU (multiplex network body ECU), the forward recognition camera stores DTC U032251. DTC
SEE MORE:
Terminals Of Ecm
TERMINALS OF ECM HINT: The standard voltage, resistance and waveform between each pair of the ECM terminals is shown in the table below. The appropriate conditions for checking each pair of the terminals is also indicated. The result of checks should be compared with the standard voltage, resistanc
Check Bus 2 Lines for Short Circuit
DESCRIPTION There may be a short circuit between the CAN main bus wire and/or CAN branch wire when the resistance between terminals 18 (CA4H) and 17 (CA4L) of the central gateway ECU (network gateway ECU) is below 54 Ω. Symptom Trouble Area
*1: w/ Headup Display
*2: w/ ASC System *3: for T
© 2016-2026 Copyright www.lexunx.com
