Lexus NX: On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to follow the correct removal and installation procedures of the front seat airbag assemblies.
PROCEDURE
1. INSPECT FRONT SEAT AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check.
Click here .gif)
(b) Visually check for defects with the front seat airbag assemblies installed on the vehicle.
(1) The defects are as follows:
- Cuts on the front seatback assembly around the front seat airbag assemblies
- Small cracks on the front seatback assembly around the front seat airbag assemblies
- Significant discoloration on the front seatback assembly around the front seat airbag assemblies
OK:
No defects are found.
HINT:
If any of the defects is found, replace the separate type front seatback cover or separate type front seatback pad with a new one.
2. INSPECT FRONT SEAT AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
(a) Perform a diagnostic system check.
Click here
(b) Visually check for defects with the front seat airbag assemblies removed from the vehicle.
(1) The defects are as follows:
- Make sure that there are no broken or frayed threads, or scratches on the surface of the base fabric of the front seat airbag assemblies
- Marks from being dropped
- Deformation on the installation part of the front seat airbag assemblies
- Cracks or other damage to the wire harness or connector
OK:
No defects are found.
HINT:
If any of the defects is found, replace the front seat airbag assembly with a new one.
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
If the side airbag was deployed, replace the front seat airbag assembly LH, separa
Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
If the side airbag was deployed, replace the front seat airbag assembly LH, s
SEE MORE:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: If the main body ECU (multiplex network body ECU) is replaced, refer to Registration. Click here HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in
Generator Temperature Sensor Circuit Low (P0A38-257,P0A39-259)
DESCRIPTION Refer to the description for DTC P0A37-260. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P0A38-257 Generator Temperature Sensor Circuit Low Short to ground in the generator temperature sensor circuit (1 trip detection
