Lexus NX: Installation
INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- If the side airbag was deployed, replace the front seat airbag assembly LH, separate type front seatback spring assembly, seatback felt, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL FRONT SEAT AIRBAG ASSEMBLY LH
(a) Install the front seat airbag assembly LH with 2 new nuts.
Torque:
5.5 N·m {56 kgf·cm, 49 in·lbf}
CAUTION:
- The nuts must not be reused.
- Make sure that the front seatback spring sub-assembly is not deformed. If it is, replace it with a new one.
(b) Attach the 2 wire harness clamps and fastener.
(c) Attach the claw to connect the airbag connector.
(d) Attach the 3 wire harness clamps.
2. INSTALL SEATBACK FELT
Click here .gif)
3. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
Click here
4. INSTALL FRONT SEAT HEADREST SUPPORT
Click here
5. INSTALL FRONT SEAT INNER CUSHION SHIELD LH
Click here
6. INSTALL FRONT SEAT CUSHION SHIELD LH
Click here
7. INSTALL FRONT SEAT LOWER CUSHION SHIELD
Click here
8. INSTALL FRONT SEAT ASSEMBLY LH
Click here
9. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
(a) Connect the cable to the negative (-) auxiliary battery terminal and tighten the nut.
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
10. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
11. INSTALL DECK FLOOR BOX LH
Click here
12. INSTALL REAR DECK FLOOR BOX
Click here
13. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
14. PERFORM DIAGNOSTIC SYSTEM CHECK
Click here
15. CHECK SRS WARNING LIGHT
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 AUXILIARY BATTERY NEGATIVE TERMINAL N*m (kgf*cm, ft.*lbf): Specified
On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to follow the correct removal and installation procedures of the lower No. 1 instrument panel airbag assembly. PROCEDURE 1. INSPECT LOWER
SEE MORE:
Readiness Monitor Drive Pattern
READINESS MONITOR DRIVE PATTERN PURPOSE OF READINESS TESTS
The On-Board Diagnostic (OBD II) system is designed to monitor the performance of emission related components, and indicate any detected abnormalities using DTCs (Diagnostic Trouble Codes). Since various components need to be monitored du
Smart access system with push-button
start
The following operations can be
performed simply by carrying the
electronic key (including the card
key) on your person, for example in
your pocket. The driver should
always carry the electronic key.
Locks and unlocks the doors
Locks and unlocks the back door
Starts and stops the hybrid
