Lexus NX: Power Steering Ecu (for Power Tilt And Power Telescopic Steering Column)
Lexus NX Service Manual / Steering / Power Assist Systems / Power Steering Ecu (for Power Tilt And Power Telescopic Steering Column)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY *2 POWER STEERING ECU ASSEMBLY *3 POWER STEERING ECU PROTECTOR *4 ECU WIRE SUB-ASSEMBLY *5 ELECTRIC POW
Removal
REMOVAL CAUTION / NOTICE / HINT PROCEDURE 1. REMOVE ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY Click here 2. REMOVE POWER STEERING ECU ASSEMBLY (a) Detach the claw and remove the power steering
Installation
INSTALLATION PROCEDURE 1. INSTALL POWER STEERING ECU ASSEMBLY (a) Install a new electric power steering motor shaft damper to the power steering ECU assembly. (b) Install a new electric power steering
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. PROCEDURE 1. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY Click here 2. REMOVE BENCH TYPE REAR SEAT CUSHION COVER (REAR SEAT CUSHION HEATER ASSEMBLY) (a) Remove the 6 hog rings.
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c)
© 2016-2026 Copyright www.lexunx.com
