Lexus NX: Precaution
PRECAUTION
PRECAUTIONS WHEN USING TECHSTREAM
(a) When using the Techstream with the vehicle power switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
(b) After all DTCs are cleared, check if the malfunction occurs again 6 seconds after the power switch is turned to on (IG).
PRECAUTION WHEN REPLACING MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
(a) If the main body ECU (multiplex network body ECU) is replaced, refer to the Smart Access System with Push-button Start (for Entry Function).
Click here .gif)
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *1 ENGINE ROOM RELAY BLOCK
- AM2 FUSE
- - ILLUSTRATION *A w/o Power Back Door System *B w/ Power Back Door System *1 BACK DOOR LOCK ASSEM
System Diagram
SYSTEM DIAGRAM Power Door Lock Control System
System Description
SYSTEM DESCRIPTION POWER DOOR LOCK CONTROL SYSTEM DESCRIPTION (a) The power door lock system locks/unlocks all doors. The main body ECU (multiplex network body ECU) receives lock/unlock request signal
SEE MORE:
Power Retractable Mirrors do not Operate with Power Retract Mirror Switch
DESCRIPTION When the outer mirror switch assembly (mirror retract switch) is operated, a retract/return signal is received by the main body ECU (multiplex network body ECU). The main body ECU (multiplex network body ECU) retracts and returns the outer rear view mirror assembly based on the received
Inspection
INSPECTION PROCEDURE 1. INSPECT SEPARATE TYPE REAR SEATBACK COVER RH (REAR SEATBACK HEATER ASSEMBLY RH) (for RH Side) (a) Check the separate type rear seatback cover RH (rear seatback heater assembly RH). (1) Measure the resistance according to the value(s) in the table below. Standard Resistance
