Lexus NX manuals

Lexus NX: Installation

Lexus NX Service Manual / Vehicle Exterior / Mirror (ext) / Outer Rear View Mirror Glass / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL OUTER MIRROR LH

(a) w/o EC Mirror:

(1) Connect the connector.

(b) w/ EC Mirror:

(1) Connect the connector(a).

(2) Connect the connector(b).

*a

Connector(a)

*b

Connector(b)

(c) Attach the 4 claws to install the outer mirror LH.

READ NEXT:

 Power Mirror Control System (w/ Memory)

 Parts Location

PARTS LOCATION ILLUSTRATION *1 INNER REAR VIEW MIRROR ASSEMBLY *2 OUTER REAR VIEW MIRROR ASSEMBLY LH *3 OUTER REAR VIEW MIRROR ASSEMBLY RH *4 OUTER MIRROR LH *5 OUTER MIRROR

 System Diagram

SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Main body ECU (multiplex network body ECU) Outer mirror control ECU assembly LH and RH Mirror surface adjust swi

SEE MORE:

 Oxygen (A/F) Sensor Heater Control Circuit Low (Bank 1 Sensor 1) (P0031,P0032,P101D)

DESCRIPTION Refer to DTC P2195. Click here HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the air fuel ratio sensor heater in fail-safe mode. Fail-safe mode continues until the power switch is turned off. Although the DTC titles say oxygen sensor, th

 Short in P Squib (Dual Stage - 2nd Step) Circuit (B1815-B1818)

DESCRIPTION The front passenger side squib 2nd step circuit consists of the airbag ECU assembly and instrument panel passenger airbag. The circuit instructs the SRS to deploy when deployment conditions are met. These DTCs are stored when a malfunction is detected in the front passenger side squib 2n

© 2016-2025 Copyright www.lexunx.com