Lexus NX: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
-
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
-
Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Vehicle Proximity Notification System
| Symptom | Suspected Area | Link |
| Sound is not produced | Refer to "There is No Sound Made" | |
READ NEXT:
TERMINALS OF ECU CHECK VEHICLE APPROACHING SPEAKER CONTROLLER (a) Disconnect the A80 vehicle approaching speaker controller connector. (b) Measure the voltage and resistance according to the value(s)
DTC CHECK / CLEAR DTC CHECK (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Vehicle Proximity No
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa
SEE MORE:
REMOVAL CAUTION / NOTICE / HINT HINT: When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment (See page ). PROCEDURE 1. PRECAUTION
INSTALLATION PROCEDURE 1. INSTALL CRUISE CONTROL MAIN SWITCH (a) Pass the wire harness under the rib as shown in the illustration. *1 Wire Harness *a Rib *b Guide Connector Screw (b) Attach the guide. (c) Temporarily install the cruise control main switch with the
© 2016-2026 Copyright www.lexunx.com
