Lexus NX: Acoustic Vehicle Alerting System
Lexus NX Service Manual / Vehicle Exterior / Acoustic Vehicle Alerting System / Acoustic Vehicle Alerting System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Problem Symptoms Table
- Terminals Of Ecu
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Speaker Circuit (B1350)
- Lost Communication with Brake System Control Module (U0129,U0140,U0293)
- There is No Sound Made
READ NEXT:
Precaution
PRECAUTION PRECAUTIONS FOR VEHICLE PROXIMITY NOTIFICATION SYSTEM (a) In the following cases, the volume or tone of the sound might change: (1) If the vehicle is parked in a very hot or cold environmen
Parts Location
PARTS LOCATION ILLUSTRATION *1 VEHICLE APPROACHING SPEAKER ASSEMBLY *2 VEHICLE APPROACHING SPEAKER CONTROLLER *3 HYBRID VEHICLE CONTROL ECU *4 INSTRUMENT PANEL JUNCTION BLOCK ASSEM
System Diagram
SYSTEM DIAGRAM
SEE MORE:
Lost Communication with Cruise Control Module (U0104,U0122,U0293)
DESCRIPTION The hybrid vehicle control ECU communicates with each sensor and ECU via CAN communication. If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored. DTC No. Detection Item DTC Detection Condition Trouble Area DTC Outp
Installation
INSTALLATION PROCEDURE 1. INSTALL STOP LIGHT SWITCH ASSEMBLY (a) Turn the stop light switch assembly in the clockwise direction until it reaches the standard shaft protrusion amount and temporarily install it. Standard: 0.5 to 1.7 mm (0.0197 to 0.0669 in.) NOTICE: Do not depress the brake pedal.
© 2016-2026 Copyright www.lexunx.com
