Lexus NX: Problem Symptoms Table
Lexus NX Service Manual / Vehicle Interior / Supplemental Restraint Systems / Occupant Classification System / Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
| Symptom | Suspected Area | Link |
|---|---|---|
| The front passenger seat condition differs from the indication by the passenger airbag ON/OFF indicator (DTC is not output). | Trouble in Passenger Airbag ON/OFF Indicator | |
.gif)
READ NEXT:
Terminals Of Ecu
TERMINALS OF ECU OCCUPANT DETECTION ECU HINT: Since the occupant detection ECU uses waterproof connectors, the voltage and waveform cannot be inspected directly. Standard voltage and waveforms are in
Diagnosis System
DIAGNOSIS SYSTEM CHECK DLC3 (a) Check the DLC3. Click here FUNCTION OF PASSENGER AIRBAG ON/OFF INDICATOR (a) Initial check (1) Turn the power switch on (IG). (2) The passenger airbag ON/OFF indicat
Dtc Check / Clear
DTC CHECK / CLEAR DTC CHECK (a) Turn the power switch off. (b) Connect the Techstream to the DLC3. (c) Turn the power switch on (IG). (d) Turn the Techstream on. (e) Enter the following menus: Body El
SEE MORE:
Precaution
PRECAUTION NOTICE: When disassembling the rear combination light assembly, use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD). STATIC ELECTRICITY COUNTERMEASURES SST SST:Desktop antistat
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL DOOR SIDE AIRBAG SENSOR LH (a) Check that the power switch is off. (b) Check that the cable is disconnected from the negative (-) aux
© 2016-2026 Copyright www.lexunx.com
