Lexus NX: Rear Disc Brake Pad
READ NEXT:
Replacement
REPLACEMENT CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
NOTICE:
When the brake pedal is first depressed after r
SEE MORE:
Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT IGNITION CONTROL RELAY (IGCT) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 3 - 5 Auxiliary battery voltage is not applied
Operation Check
OPERATION CHECK INITIAL CHECK (a) Power switch on (IG) (intuitive parking assist system off). (b) Intuitive parking assist system on and check an indication state of the vehicle mark. OK: The initial check is performed for approximately 5 seconds after the system turns on, and then the system switc
© 2016-2026 Copyright www.lexunx.com
