Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *A | w/ AVS | - | - |
| *1 | REAR SPEED SENSOR LH | - | - |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | w/o AVS | - | - |
| *1 | REAR SPEED SENSOR LH | - | - |
| | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
PROCEDURE 1. RELEASE PARKING BRAKE Click here 2. REMOVE
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL REAR SPEED SENSOR LH (w/ AVS)
Steering Angle Sensor
ComponentsCOMPONENTS ILLUSTRATION *A w/o Steering Heater *B w/ Steering Heater *1 STEERING SENSOR *2 SPIRAL CABLE SUB-ASSEMBLY RemovalREMOVAL PROCEDURE 1. REMOVE SPIRAL W/SENS
SEE MORE:
DCM Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area DCM Communication Stop Mode Any of the following conditions are met:
Communication stop for "DCM" is indicated on the "Communication Bus Check" screen of the Techstream.
Click here
Communication system DTCs (DTCs that start with U)
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL FRONT DOOR OUTSIDE MOULDING SUB-ASSEMBLY LH (a) Attach the 3 claws to install the front door outside moulding sub-assembly LH. (b) In
© 2016-2026 Copyright www.lexunx.com
