Lexus NX: Remote Service Malfunction
PROCEDURE
| 1. | CHECK CAN COMMUNICATION SYSTEM |
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Bus Check.
Click here .gif)
(e) Check that all ECUs and sensors that use CAN communication are connected.
| Result | Proceed to |
|---|---|
| There are no connection problems. | A |
| There is a connection problem. | B |
| B | .gif) | GO TO CAN COMMUNICATION SYSTEM |
|
.gif)
| 2. | CHECK DTC OUTPUT |
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG) and wait for 90 seconds.
(c) Turn the Techstream on.
(d) Enter the following menus: Health Check.
(e) Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output. | A |
| DTCs are output. | B |
| B | | INSPECT EACH ECU SYSTEM |
|
| 3. | CHECK OPERATION OF EACH SYSTEM |
(a) Check that each system related to Lexus Enform Remote operates normally.
(1) Check power door lock control system
Click here
(2) Check smart access system with push-button start (for Entry Function)
Click here
(3) Check smart access system with push-button start (for Start Function)
Click here
(4) Check immobiliser system
Click here
(5) Check theft deterrent system
Click here
(6) Check lighting system (INT)
Click here
(7) Check meter/gauge system
Click here
(8) Check air conditioning system
Click here
(9) Check power window control system
Click here
(10) Check sliding roof system
Click here
(11) Check power back door system
Click here
(12) Check lighting system (EXT) (for Triple Beam Headlight)
Click here
(13) Check lighting system (EXT) (for Single Beam Headlight)
Click here
| Result | Proceed to |
|---|---|
| All of the systems related to Lexus Enform Remote operate normally. | A |
| Any system related to Lexus Enform Remote does not operate normally. | B |
| B | | GO TO ABNORMAL SYSTEM |
|
| 4. | CHECK DCM OPERATION HISTORY |
(a) Check DCM Operation History.
Click here
| Tester Display |
|---|
| DCM Operation History |
| NEXT | | CONTACT SERVICE CENTER |
READ NEXT:
Warning Notification Function Malfunction
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following
SEE MORE:
Front Passenger Side Power Mirror cannot be Adjusted with Power Mirror Switch
DESCRIPTION When the outer mirror switch assembly mirror surface adjust switch (up/down/left/right) is operated, up/down/left/right signals are received by the main body ECU (multiplex network body ECU). The main body ECU (multiplex network body ECU) sends the received signals to the outer mirror co
Automatic High Beam System (B124B)
DESCRIPTION The main body ECU (multiplex network body ECU) determines the status of the automatic high beam system based on the automatic high beam system signal from the forward recognition camera. DTC No. Detection Item DTC Detection Condition Trouble Area B124B Automatic High Beam
