Lexus NX: Telematics System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Utility
- Problem Symptoms Table
- Terminals Of Ecu
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Lost Communication with Body Control Module Missing Message (U014087,U015587,U016387)
- Remote Engine Starter does not Operate
- Remote Service Malfunction
- Warning Notification Function Malfunction
READ NEXT:
Precaution
PRECAUTION WHEN DISCONNECTING AUXILIARY BATTERY CABLE (a) After the power switch is turned off, the radio receiver assembly requires approximately 6 minutes to record various types of memory and setti
Parts Location
PARTS LOCATION ILLUSTRATION *1 NO. 2 ENGINE ROOM RELAY BLOCK - DCM FUSE *2 TELEPHONE AND GPS ANTENNA (ROOF ANTENNA ASSEMBLY) ILLUSTRATION *1 TELEPHONE ANTENNA (NAVIGATION ANTENNA AS
System Diagram
SYSTEM DIAGRAM
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY Click here 2. REMOVE INVERTER WITH CONVERTER ASSEMBLY Click here 3. REMOVE INVERTER WATER PUMP WITH MOTOR ASSEMBLY Click here 4. REMOVE INVERTER BRACKET ASSEMBLY Click here 5. DISCONNECT WIRE HARNESS (a) Disconnect the 4
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE 1. INSTALL CLEARANCE LIGHT ASSEMBLY LH (a) Attach the 2 claws to install the clearance light assembly LH. (b) Install the 3 screws and clip.
© 2016-2026 Copyright www.lexunx.com
