Lexus NX: Side Camera RH Internal Circuit (C2A62)
Lexus NX Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Panoramic View Monitor System / Side Camera RH Internal Circuit (C2A62)
DESCRIPTION
This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the side television camera assembly RH via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C2A62 | Side Camera RH Internal Circuit | A signal indicating a malfunction in the side television camera assembly RH is detected. | Side television camera assembly RH |
CAUTION / NOTICE / HINT
NOTICE:
-
When "!" mark is displayed on the multi-display assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.
Click here
.gif)
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Clear the DTCs.
Click here
(b) Check for DTCs.
Click here
OK:
DTC C2A62 is not output.
| OK | .gif) | END |
| NG | | REPLACE SIDE TELEVISION CAMERA ASSEMBLY RH |
READ NEXT:
Back Camera Internal Circuit (C2A63)
DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the rear television camera assembly via CAN communication. DTC No. Detection Item DTC Det
Back Camera Response Malfunction (C2A6A)
DESCRIPTION During self diagnosis of the parking assist ECU, the parking assist ECU sends display mode ID signals to the rear television camera assembly. This DTC is stored when the output of the rear
Side Camera LH Response Malfunction (C2A6B)
DESCRIPTION During self diagnosis of the parking assist ECU, the parking assist ECU sends display mode ID signals to the side television camera assembly LH. This DTC is stored when the output of the s
SEE MORE:
Inspection Mode Procedure
INSPECTION MODE PROCEDURE NOTICE: When operating the vehicle in inspection mode for an operation such as a speedometer test, a DTC may be set. Therefore, if the warning light comes on, after canceling inspection mode, check for DTCs using the Techstream and clear the DTCs. HINT:
If the engine is
Zero Point Calibration of Yaw Rate Sensor undone (C1210,C1336)
DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) receives signals from the yaw rate and acceleration sensor (airbag ECU assembly) via CAN communication. The airbag ECU assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition using 2 cir
© 2016-2026 Copyright www.lexunx.com
