Lexus NX: Panoramic View Monitor System

READ NEXT:

 Precaution

PRECAUTION POINTS TO NOTE WHEN SERVICING (a) Pay attention to the following points when servicing. (1) When disconnecting the cable from the negative (-) auxiliary battery terminal, "!" mark may appea

 Parts Location

PARTS LOCATION ILLUSTRATION *A w/ Blind Spot Monitor System - - *1 FRONT TELEVISION CAMERA ASSEMBLY *2 REAR TELEVISION CAMERA ASSEMBLY *3 SIDE TELEVISION CAMERA ASSEMBLY RH

 System Diagram

SYSTEM DIAGRAM Sender Receiver Signal Line *: w/ Blind Spot Monitor System Parking Assist ECU Multi-display Assembly Display GVIF cable Radio Receiver Assembly Multi-di

SEE MORE:

 Cellular Phone Registration Failure

CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur: A communication malfunction DTC may be stored. The radio receiver assembly may not

 Manual(sos)switch

InspectionINSPECTION PROCEDURE 1. REMOVE MAP LIGHT ASSEMBLY Click here 2. INSPECT MAP LIGHT ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. *a Component without harness connected (Map Light Assembly) - - Resistance: Test

© 2016-2026 Copyright www.lexunx.com