Lexus NX: Steering Angle Initialization Incomplete (C1694)
Lexus NX Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Parking Assist Monitor System / Steering Angle Initialization Incomplete (C1694)
DESCRIPTION
This DTC is stored when the rear television camera assembly judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1694 | Steering Angle Initialization Incomplete | Maximum steering angle has not been memorized (steering angle setting is incomplete) |
|
CAUTION / NOTICE / HINT
NOTICE:
-
When "!" mark is displayed on the multi-display assembly after disconnecting the cable from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.
Click here
.gif)
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.
Click here
PROCEDURE
| 1. | ADJUST SETTINGS (STEERING ANGLE SETTING) |
(a) Perform steering angle setting.
(1) Steering angle setting.
Click here
|
.gif)
| 2. | CHECK FOR DTC |
(a) Clear the DTCs.
Click here
(b) Check for DTCs.
Click here
HINT:
- If DTC C1694 is output, perform the steering angle setting again.
- If DTC C1694 is still output after performing the steering angle setting 3 times, replace the rear television camera assembly.
| Result | Proceed to |
|---|---|
| DTC C1694 is not output | A |
| DTC C1694 is output | B |
| A | .gif) | END |
| B | | REPLACE REAR TELEVISION CAMERA ASSEMBLY |
READ NEXT:
Engine ECU Communication (U0100,U0126,U0140,U0163,U0233,U1110)
DESCRIPTION These DTCs are stored if there is a malfunction in the CAN communication system connected to the rear television camera assembly. HINT: If CAN communication system DTCs are stored, they ma
CAN Communication Failure (Message Registry) (U1000)
DESCRIPTION This DTC is stored when the rear television camera assembly judges that it has an internal CAN malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area U1000
Reverse Signal Circuit
DESCRIPTION The multi-display receives a reverse signal from the BK UP LP relay*1 or clearance warning ECU assembly*2. *1: except 10.3 Inch Display and w/ Intuitive Parking Assist System *2: for 10.3
SEE MORE:
Data List / Active Test
DATA LIST / ACTIVE TEST NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
When diagnosing symptoms such as hesitation, rough idle, or other small symptoms usi
Removal
REMOVAL PROCEDURE 1. REMOVE DOOR SCUFF PLATE ASSEMBLY LH Click here 2. REMOVE COWL SIDE TRIM BOARD LH Click here 3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here 4. REMOVE STOP LIGHT SWITCH ASSEMBLY (a) Disconnect the connector. (b) Loosen the lock
© 2016-2026 Copyright www.lexunx.com
