Lexus NX: Steering Angle Sensor (C1A47)
DESCRIPTION
The blind spot monitor sensor receives steering angle signals from the steering sensor via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| C1A47 | Steering Angle Sensor | A fail flag is transmitted from the steering sensor |
| - |
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch (combination switch assembly) is on.
PROCEDURE
| 1. | CHECK DTC |
(a) Clear the DTCs.
Click here .gif)
(b) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble CodesOK:
DTC C1A47 is not output.
| OK | .gif) | USE SIMULATION METHOD TO CHECK |
|
.gif)
| 2. | REPLACE STEERING SENSOR |
(a) Replace the steering sensor.
Click here
|
| 3. | RECHECK DTC |
(a) Clear the DTCs.
Click here
(b) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes| Result | Proceed to |
|---|---|
| DTC C1A47 is not output | A |
| DTC C1A47 is output from the blind spot monitor sensor LH (master) | B |
| DTC C1A47 is output from the blind spot monitor sensor RH (slave) | C |
| A | | END (STEERING SENSOR WAS DEFECTIVE) |
| B | | REPLACE BLIND SPOT MONITOR SENSOR LH |
| C | | REPLACE BLIND SPOT MONITOR SENSOR RH |
READ NEXT:
Short to +B in Outer Mirror Indicator(Master) (C1AB0)
DESCRIPTION This DTC is stored when the blind spot monitor sensor LH detects a +B short in the outer rear view mirror indicator LH. DTC No. Detection Item DTC Detection Condition Trouble Area
Short to +B in Outer Mirror Indicator(Slave) (C1AB1)
DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects a +B short in the outer rear view mirror indicator RH. DTC No. Detection Item DTC Detection Condition Trouble Area
Short to GND in Outer Mirror Indicator(Master) (C1AB2)
DESCRIPTION This DTC is stored when the blind spot monitor sensor LH detects a ground short in the outer rear view mirror indicator LH. DTC No. Detection Item DTC Detection Condition Trouble
SEE MORE:
Engine Coolant Temperature Circuit (P0115,P0117,P0118)
DESCRIPTION A thermistor, whose resistance value varies according to the engine coolant temperature, is built into the engine coolant temperature sensor. The structure of the sensor and its connection to the ECM are the same as those of the intake air temperature sensor. HINT: When DTC P0115, P0117
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL FRONT SEAT WIRE LH (for Driver Side) (a) Attach the
