Lexus NX: Steering wheel
Adjustment procedure
Manual type
1. Hold the steering wheel and push the lever down.
2. Adjust to the ideal position by moving the steering wheel horizontally and vertically.
After adjustment, pull the lever up to secure the steering wheel.
Power type
Operating the switch moves the steering wheel in the following directions:
- Up
- Down
- Toward the driver
- Away from the driver
■The steering wheel can be adjusted when The power switch is in ACCESSORY or ON mode*.
*: If the driver's seat belt is fastened, the steering wheel can be adjusted regardless of power switch mode.
■Automatic adjustment of the steering position (if equipped) A desired steering position can be entered to memory and recalled automatically by the driving position memory system.
■Power easy access system (if equipped) The steering wheel and driver's seat move in accordance with power switch mode and the driver's seat belt condition.
■After adjusting the steering wheel (manual type) Make sure that the steering wheel is securely locked.
The horn may not sound if the steering wheel is not securely locked.
WARNING
■Caution while driving Do not adjust the steering wheel while driving.
Doing so may cause the driver to mishandle the vehicle and cause an accident, resulting in death or serious injury.
■After adjusting the steering wheel (manual type) Make sure that the steering wheel is securely locked.
Otherwise, the steering wheel may move suddenly, possibly causing an accident, resulting in death or serious injury.
Sounding the horn
To sound the horn, press on or close to
the 
mark.
READ NEXT:
Inside rear view mirror
The rear view mirror's position can
be adjusted to enable sufficient
confirmation of the rear view.
Adjusting the height of rear view
mirror
The height of the rear view mirror can
be adjusted to
Outside rear view mirrors
For safe driving, adjust the mirror
angles to secure visibility before
driving.
WARNING
■When driving the vehicle
Observe the following precautions while
driving.
Failure to do so may resul
SEE MORE:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE:
If no problem symptoms are found when a DTC is output in the DTC check on the lane tracing assist, check each symptom by checking the suspected areas in the order they are listed.
When replacing the combination meter assembly, always replace it with a new one. If
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR WIPER MOTOR ASSEMBLY *a Component without harness connected (Rear Wiper Motor Assembly) (a) Check that the rear wiper motor assembly operates. NOTICE: Check that the body ground is connected. (1) Apply auxiliary battery voltage to the rear wiper motor co
