Lexus NX: Stop Light Relay Actuator Stuck (C142571)
DESCRIPTION
The stop light switch assembly and skid control ECU (brake booster with master cylinder assembly) outputs stop light signals. When the skid control ECU (brake booster with master cylinder assembly) detects a malfunction relating to the stop light circuit, the forward recognition camera is notified via CAN communication, and C142571 is output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C142571 | Stop Light Relay Actuator Stuck | Once 3 seconds elapse after turning the power switch on (IG), the system receives a stop light circuit malfunction signal from the skid control ECU (brake booster with master cylinder assembly) for approximately 1 second or more. | Electronically controlled brake system |
PROCEDURE
| 1. | CHECK ELECTRONICALLY CONTROLLED BRAKE SYSTEM |
(a) Check electronically controlled brake system.
Click here .gif)
HINT:
- When C142571 is detected by the pre-collision system, C1380 may also be detected in the electronically controlled brake system. Therefore, check the electronically controlled brake system first when C142571 is detected.
| NEXT | .gif) | END |
READ NEXT:
Lost Communication With Multi-axis Acceleration Sensor Module Missing Message (U012587,U012687,U012987,U029387)
DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area U012587 Lost Communication With Multi-axis Acceleration Sensor Module Missing Message While the vehicle is bein
Lost Communication with Cruise Control Front Distance Range Sensor Missing Message (U023587)
DESCRIPTION The forward recognition camera is connected to the millimeter wave radar sensor assembly via the CAN communication line. When the signal from the millimeter wave radar sensor assembly is i
Lost Communication with Image Processing Module "A" (U023A87)
DESCRIPTION The forward recognition camera is connected to the skid control ECU (brake booster with master cylinder assembly) via the CAN communication line. When the skid control ECU (brake booster w
SEE MORE:
Display Malfunction (B15A6,B15B0)
DESCRIPTION These DTCs are stored when a malfunction occurs in the multi-display assembly. DTC No. Detection Item DTC Detection Condition Trouble Area B15A6 Display Malfunction When one of the conditions below is met:
RAM error
Drawing controller malfunction
Internal hard dri
Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION:
Wear protective gloves when removing the exhaust pipe assembly.
The exhaust pipe assembly is extremely hot immediately after the engine has stopped.
Confirm that the exhaust pipe assembly has cooled down before removing it.
PROCEDURE 1. REMOVE TAIL
